I am a DIYer and I formerly owned an Incra Positioner but found the process to be too cumbersome when I needed to change my cuts.I saw this fence reviewed on Wood Whisperer and after much research I decided to pull the trigger on buying one.
When the fence arrived it was well packed and had all the parts listed on the packing list. The quality/manufacturing of all the parts was first class. Prior to mounting the fence I had to install some Biesemeyer rails I had bought. Mounting the rails was the most difficult part as the bolt holes had to be drilled and tapped. Once the rails were mounted, and following the excellent instructions, the fence was installed, adjusted and ready to use in about 30 minutes. The saw I mounted the fence on is a General 2 HP contractor saw. I have yet to use any jigs on the fence but I am sure it will be easy when do decide to use it on the extruded aluminum. I am looking forward to adding a digital scale. I would recommend this fence to anyone and would buy it again.” – Fred
“The quality/manufacturing of all the parts was first class.” ~ Fred
VERYSUPERCOOL TOOLS TABLE SAW FENCE SYSTEM REVIEW by Fred (submitted through our website)
As all the above remarked the table saw fence system arrived promptly and it was well packaged. My only question is why oh why did I put up with the factory table saw fence that was at best marginal from the beginning. Set up for the VSC fence was easy and the straight forward method for dialing it in gave me a good deal of confidence that it will stay accurate over time, unlike my original fence. I am throwing out all the old jigs and fence covers that I never had the room to store.